XYZ1550 Manual Gap Bed Centre Lathe (Approx year 2000)

Lot 15 - XYZ1550 Manual Gap Bed Centre Lathe (Approx year 2000)

Description:

XYZ1550 Manual Gap Bed Centre Lathe (Approx year 2000)
Newall C80 DRO

3 jaw chuck with extra jaws
QCTP and holders
3 point fixed steady
Low Volt Light
Coolant tray and pump
Height of centre 190mm. (7-1/2")
Distance between centres 1250mm(50")
Swing over bed 390mm. (15-1/4")
Swing over cross slide 240mm. (9-1/2")
Swing in gap 610mm. (24")
Width of gap in front of faceplate 150mm. (6")
Spindle nose D-1-6 Spindle bore 54mm (2-1/8")
Spindle bore taper M. T. No. 6Taper of centre M. T. No. 4
Spindle speed Range 25,35,45,60,80, 110,140,190,260,360,475,630,845,
1140,1520,2000Rpm
Main motor 5.5kw (7.5HP.)
Width of bed Length of bed 280mm. (11")
Cross slide travel 230mm. (9-1/4")
Approx. Net/Gross weight 1500kgs. (2860/3300 lbs. Overall dimension (L. X W.
X H.) (99" X 42" X 63")

Located: Leicester - loaded FOC

Export Information

Please note: If you are successful in purchasing an item and wish to export it from the UK, a charge of £75.00 will be automatically added to your invoice to cover preparation of the goods and completion of the required UK export customs declarations. This process has been a mandatory UK export requirement since 1 January 2021.

All invoices are issued on an Incoterms FCA basis.

Exports outside the EU may require an export licence. Where applicable, a further charge of £250.00 will be automatically added to your invoice. Please also note that, while an export licence is being processed, the purchaser is responsible for placing into storage until the licence is issued.

* Please note all dimensions stated are approximate, however the accuracy cannot be guaranteed and should be verified by the bidder before bidding.

Recommended Transport